Trailer Bullet
Click on pictures to enlarge.
We now accept
 

Download the Trailer bullet instructions here... PDF

Images maybe enlarged by clicking on them.

We are currently seeking for Distributors for The "Trailer Bullet"  This is a brand new locking system for semi-trailers, goosenecks or any trailer system with dolly legs.  Fill out the form below to contact us about becoming  a distributor in your area. 

This lock will not work on hydraulic jacks, but will work on some electric applications contact us to find out if you are unsure.

The Trailer Bullet components show above

Installing the "Bullet"

1. Unthread Bolt form Bullet with 5/16” Allen Wrench

2. Remove existing bolt from jack - maybe installed on either side of jack or on the crossover shaft

3. Replace hex head cap bolt into bullet

4. Apply thread lock compound to threads of bolt (mandatory)

5. Insert bolt into existing hole in jack

6. Add lock washer and thread into bottom half of bullet

To Lock:

7. Slide locking Barrels with tabs over each end of bullet and align holes

8. Insert Padlock into holes in tabs

9. Enjoy the Peace of Mind You Will have knowing your trailer is safe and secure!

The bullet installs in steps 1-6 and remains on the trailer at all times. When lock is applied the jack will not turn, keeping anyone from hooking to your trailer.

Curb side dolly leg of semi-trailer

Crank side of dolly leg on semi-trailer

Crank side of dolly leg on semi-trailer

Crank side of dolly leg on semi-trailer without locking rods (just the bullet showing)

Crank side of dolly leg on semi-trailer without locking rods (just the bullet showing)

Installed on a Semi-Trailer

Benefits

• Installs in just minutes
• May be installed on either side of jack
• If installed on the crossover shaft it's almost invisible
• Once the bullet is installed it stays there. Just toss the locking barrels in your vehicle/cab and take them out when you need to secure your trailer.
• Made in the USA